Adhesive Surface Preparataion


The activators are specially designed products to speed up the cure of Anaerobic Adhesives. Typical conditions of use are low temperatures, large gaps, inactive or passive surfaces


For anaerobic and acrylic adhesives
ACTIVATOR 11

Solvent based formulated accelerator, available in liquid and aerosol form. Fixture time about 1 minute.

ACTIVATOR 17

Solvent free Activator to set up polymerisation of acrylic adhesives. Good polymerisation effects on ferrites, metals and ceramics. Fixture time about 1-2 minutes.

ACTIVATOR 18

Liquid accelerator, solvent free, odourless. Fixture time about 1 minute.

ACTIVATOR 20

Liquid accelerator, solvent free, for contact curing adhesives and anaerobics. Fi xture time 1-2 minutes.

Cleaners and Removers
CLEANER 10

Fast drying cleaner and degreaser to optimally prepare the surfaces to be bonded. Suitable for metal, ceramics, rubbers and plastics. Available in aerosol form

CR 1

CA remover solvent based. To remove and clean from cured CA adhesive and to debond parts cured with CA adhesives.

CR 5

Low odor, low volatility solvent to be used to detach and remove silicones, Ms Polymers and two-part modified epoxy adhesives f rom many kinds of surfaces. Also available in gel formulation (CR5 gel).

For cyanoacrylate adhesives
PRIMER 7

Liquid primer for difficult plastics, PE, PP, Elastomers, Silicone and PTFE. Speed up curing and avoid blooming effect.

ACTIVATOR 9

For instant curing of Cyanacrylate adhesives on porous or acidic surfaces. Eliminates the blooming effect. To be used as primer or after assembling, curing excess adhesive outside the joint. Available as liquid formulation or aerosol.

Top