Adhesive Surface Preparataion
The activators are specially designed products to speed up the cure of Anaerobic Adhesives. Typical conditions of use are low temperatures,
large gaps, inactive or passive surfaces
For anaerobic and acrylic adhesives
Solvent based formulated accelerator, available in liquid and aerosol form. Fixture time about 1 minute.
Solvent free Activator to set up polymerisation of
acrylic adhesives. Good polymerisation effects on
ferrites, metals and ceramics. Fixture time about
Liquid accelerator, solvent free, odourless.
Fixture time about 1 minute.
Liquid accelerator, solvent free, for contact curing
adhesives and anaerobics.
xture time 1-2 minutes.
Cleaners and Removers
Fast drying cleaner and degreaser to optimally
prepare the surfaces to be bonded. Suitable for
metal, ceramics, rubbers and plastics.
Available in aerosol form
CA remover solvent based. To remove and clean
from cured CA adhesive and to debond parts cured
with CA adhesives.
Low odor, low volatility solvent to be used to
detach and remove silicones, Ms Polymers and
two-part modified epoxy adhesives f
kinds of surfaces.
Also available in gel formulation (CR5 gel).
For Cyanoacrylate adhesives
Liquid primer for difficult plastics, PE, PP,
Elastomers, Silicone and PTFE. Speed up curing
and avoid blooming effect.
For instant curing of Cyanoacrylate adhesives on
porous or acidic surfaces. Eliminates the
blooming effect. To be used as primer or after
assembling, curing excess adhesive outside the
joint. Available as liquid formulation or aerosol.